Усі міжнародні тренажери на платформі IG MARITIME — безкоштовні для всіх моряків. Зареєструйтеся один раз, щоб зберігати свій прогрес і готуватися до рейсу без обмежень!

Виберіть набір запитань і почніть навчання або іспит.

Про цей набір

База Seagull CBT поділена на навчальні модулі: безпека, суднові операції, технічне обслуговування та інші теми. Назви й коди модулів збережено, щоб ви могли вибрати потрібну тему підготовки.

У наборі «Seagull CBT — CD0041. Generator» — 34 запитань. Доступний 1 набір.

Навчання

У навчанні немає таймера: після відповіді ви одразу побачите результат і правильні варіанти. Можна повернутися до запитання та повторити тему.

Іспит

Іспит триває до 60 хвилин і містить до 50 запитань із вибраного набору. Правильні відповіді та результат доступні після завершення.

Приклади запитань і відповідей

Це приклади з опублікованого набору. Для послідовної підготовки виберіть «Навчання», для перевірки знань — «Іспит».

Which control mode is recommended during manoeuvring?

Один правильний варіант

  • Optimal, because this mode allows an increased load of the generators during manoeuvring
  • Equal, because of the wider control range which allows the low priority generator(s) to be connected at low loads✓ Правильна відповідь
  • Cyclic, because the risk of fouling of intake channels are eliminated, and because of this the risks of reduced capacity of the generators are minimised
What will happen if Load dependent start/stop of generator sets is in auto mode?

Один правильний варіант

  • It will start/stop the generator sets in response to varying load✓ Правильна відповідь
  • It will start/stop the generator sets in response to fuel consumption
  • It will start but never stop the generator sets in response to varying load
  • It will stop but never start the generator sets in response to varying load
The kW and kVAr instruments on the main switchboard reads respectively 630 kW and 400 kVAr. What is the actual power factor?

Один правильний варіант

  • 0.8
  • 0.85✓ Правильна відповідь
  • 0.9
How could you monitor the correct instant for synchronising without the aid of a synchroscope or synchronising lamps?

Один правильний варіант

  • By connecting a pair of voltmeter probes across one phase of the incoming generator circuit breaker, and then adjusting the generator speed until the voltmeter slowly fluctuates from zero to maximum. Connect the breaker when the voltmeter passes through zero✓ Правильна відповідь
  • It is not possible to synchronise generators without the synchronising aids
  • By off-loading the running generator to a minimum to avoid large "kicks" at connection. Adjust the incoming generator to a frequency slightly less than the running generator. The running generator will then "pull" the incoming generator into synchronism
Which statement is true?

Один правильний варіант

  • The Priority 1 generator will be first IN / first OUT
  • The Priority 1 generator will be first IN / last OUT✓ Правильна відповідь
  • At Cyclic control mode the generators change Priority order

Перед початком підготовки

Чи потрібна реєстрація, щоб почати?

Гостьовий доступ триває 23 хвилин. Безкоштовна реєстрація дає змогу продовжити без обмежень, зберігати прогрес і повертатися до помилок в особистому кабінеті.

Якою мовою будуть запитання?

Запитання та варіанти відповідей зберігають мову вихідної бази. Мову інтерфейсу можна змінити окремо.

Чи можна використати результат як офіційний документ?

Ні. Це самостійна підготовка. Результат не замінює іспит, свідоцтво або перевірку знань в уповноваженій організації.