IG MARITIMEMade by Seafarers for Seafarers

All international training tests on IG MARITIME are free for every seafarer. Register once to save your progress and prepare for your next voyage without limits!

EO1-Use Hand and Power Tools for Fabrication and Repair

Search this section

Choose a question set and start learning or take an exam.

About this collection

Videotel questions are grouped by professional topic, including machinery, electrical equipment, fuel and ballast operations. Choose a subject relevant to your preparation.

“Видеотел — Engine Category — EO1-Use Hand and Power Tools for Fabrication and Repair” contains 172 questions across 1 collection.

Learning

Learning mode has no timer. After answering, you see feedback and the correct options. You can return to a question and repeat a topic.

Exam

A practice exam lasts up to 60 minutes and includes up to 50 questions from the selected collection. Correct answers and results appear after completion.

Sample questions and answers

These examples come from the published collection. Choose Learning to study questions in sequence, or Exam to check your knowledge.

What kind of tool is shown bottom left ? What is its use ?Question illustration

One correct answer

  • 1) Mason's chisel / To break up cement boxes.
  • 2) Blacksmith's chisel / To cut steel bars and rods.
  • 3) Hot chisel / To cut bolts and nuts.
  • 4) Cold chisel / A general purpose cutting and splitting tool.✓ Correct answer
A scriber should not be used for marking out?Question illustration

One correct answer

  • 1) When material is copper.
  • 2) When material is to be bent.✓ Correct answer
  • 3) When material is to be hot worked.
  • 4) When material is plastic.
Perspex is an example of a thermoplastic, How is this best heated prior to bending?The source image is unavailable.

One correct answer

  • 1) Heat in an oven.
  • 2) Heat in boiling water.✓ Correct answer
  • 3) Flame heat.
  • 4) Hot air stream.
What is the function of this hydraulic stressing tool when fastening and unfastening bolts/nuts on an engine ?Question illustration

One correct answer

  • 1) To fasten or unfasten the nut.
  • 2) To press the part to be fastened together or down so that the nut can be tightened by hand.
  • 3) To apply pressure on cylinder head or bearing so that the bolts/nuts can be tightened by hand.
  • 4) To elongate the bolts at required stress value so that the nuts can be tightened to the position to ensure correct pre-tensioning.✓ Correct answer
A method of joining two plastics together is by solvent welding. What is this process?The source image is unavailable.

One correct answer

  • 1) Application of a thin film of adhesive to joining surfaces.
  • 2) Adhesive is applied and dissolves the plastic material being joined.✓ Correct answer
  • 3) A heating tool is applied with pressure to required join.
  • 4) A high frequency current is applied to clamps at the join.

Before you start

Do I need to register to start?

Guest access lasts 23 minutes. Free registration lets you continue without limits, save progress and review mistakes in your account.

What language are the questions in?

Questions and answer options retain the language of the original bank. You can change the interface language separately.

Can I use my result as an official document?

No. This is independent practice. A result does not replace an examination, certificate or knowledge check by an authorised organisation.