Engine Category > EO1-Use Hand and Power Tools for Fabrication and Repair

Choose a question set and start learning or take an exam.

Engine Category > EO1-Use Hand and Power Tools for Fabrication and Repair
101 questions
Search

About this collection

Videotel questions are grouped by professional topic, including machinery, electrical equipment, fuel and ballast operations. Choose a subject relevant to your preparation.

“Видеотел — Engine Category > EO1-Use Hand and Power Tools for Fabrication and Repair” contains 101 questions across 1 collection.

Learning

Learning mode has no timer. After answering, you see feedback and the correct options. You can return to a question and repeat a topic.

Exam

A practice exam lasts up to 60 minutes and includes up to 50 questions from the selected collection. Correct answers and results appear after completion.

Sample questions and answers

These examples come from the published collection. Choose Learning to study questions in sequence, or Exam to check your knowledge.

What kind of tool is shown bottom left ? What is its use ?

One correct answer

1) Mason's chisel / To break up cement boxes.
2) Blacksmith's chisel / To cut steel bars and rods.
3) Hot chisel / To cut bolts and nuts.
4) Cold chisel / A general purpose cutting and splitting tool.✓ Correct answer

A scriber should not be used for marking out?

One correct answer

1) When material is copper.
2) When material is to be bent.✓ Correct answer
3) When material is to be hot worked.
4) When material is plastic.

What is the function of this hydraulic stressing tool when fastening and unfastening bolts/nuts on an engine ?

One correct answer

1) To fasten or unfasten the nut.
2) To press the part to be fastened together or down so that the nut can be tightened by hand.
3) To apply pressure on cylinder head or bearing so that the bolts/nuts can be tightened by hand.
4) To elongate the bolts at required stress value so that the nuts can be tightened to the position to ensure correct pre-tensioning.✓ Correct answer

For a particular welding arrangement, the decision is to use a manifold system. Why would this be chosen?

One correct answer

1) Because of the long time span of welding
2) The discharge rate is too high from single bottle✓ Correct answer
3) Better stability when using large bore nozzles
4) Cost - two cylindersare cheaper than one

The square to round section shown requires a template. What forms the triangular base line from which the true lengths are obtained?

One correct answer

1) ab a1
2) a1 a2✓ Correct answer
3) a2 ab
4) ax ab

Before you start

Do I need to register to start?

Guest access lasts 23 minutes. Free registration lets you continue without limits, save progress and review mistakes in your account.

What language are the questions in?

Questions and answer options retain the language of the original bank. You can change the interface language separately.

Can I use my result as an official document?

No. This is independent practice. A result does not replace an examination, certificate or knowledge check by an authorised organisation.